CX machines are Windows XP and Vista (32bit) compatible only.

Roland Camm 1 Pnc 1000 Software Includes A

The software includes a Windows driver, Windows plug-ins for Adobe Illustrator and CorelDRAW, and Mac Plug-in for Illustrator.

The result is a seamless, user-friendly operating environment.

To navigate to your regional website, please use our region selector.

When the SETUP key has been pressed and cutting data is sent, the data is stored in the buffer at the same time that it is cut.

To ensure correct and safe usage with a full understanding of this products performance, please be sure to read through this manual completely and store it in a safe location.

ROLAND DG CORPORATION 1-6-4 Shinmiyakoda, Hamamatsu-shi, Shizuoka-ken, JAPAN 431-2103 MODEL NAME: See the MODEL given on the rating plate.

The following figure describes the location and content of these messages.

Power Connector (AC IN) This connector accepts standard AC power cord.

Operation Panel The TEST key and the position keys function only when the SETUP LED is lighted.

DIP switch Function SW-1 Baud rate 9600 4800 SW-2 Parity check Disable Enable SW-3 Parity check EVEN SW-4 Data bits 8-bits 7-bits SW-5 Stop bits 1-bit.

Doing so may result in injury, and the cutting performance of the blade will be impaired.

NOTICE Be sure to support the tool mounting screw from below when installing the blade holder.

Cutting quality may become poor if installed without supporting the screw in this way.

The cutting carriage moves simultaneously when the power is switched on.) Switch on the power switch on the left side of the CM-2412.

Move the material from side to side and position so that the left-hand edge of the material lies over the leftmost grit roller.

This is done by examining the results of the cutting test, and adjusting the blade force and the amount of blade extension.

The cutting test should be repeated until the appropriate cutting conditions for the material in use are discovered.

Move the blade force control slider sideways to alter the blade force.

The pen force control slider can be positioned at marks indicating the 11 levels available.

The unit will begin cutting when it receives cutting data sent from the computer.

Roland Camm 1 Pnc 1000 How To Install The

For information on how to install the CAMM-1 DRIVER for Windows.

Failure to do so may result in danger of shock, electrocution, or fire due to deterioration of the electrical insulation.

If the CM-2412 is not performing correctly, follow the steps below to perform a self-test.

If there is still unused material on the right side, rotation allows you to use this remaining material effectively.

When the character string Roland is rotated by 90, the X axis, Y axis, and origin change as follows.

Before cutting, plotting using pen and paper can ensure that your design is correct without wasting materials.

Since the design of the CM-2412 differs inherently from that of dedicated plotters, it does not accommodate functions such as high-speed plotting, automatic pen changes, pen dry protection, or the like.

Roland Camm 1 Pnc 1000 Drivers For Mac